How to design the cabinet lighting? Look here

01 importance of cabinet lighting
Whether in home life or in commercial stores, the cabinets in different areas meet different functions. The TV cabinet in the living room, the kitchen cabinet, the bedroom wardrobe, the store laminate cabinet and the sam
From:SEEPOSH—Connie
01 importance of cabinet lighting
Whether in home life or in commercial stores, the cabinets in different areas meet different functions. The TV cabinet in the living room, the kitchen cabinet, the bedroom wardrobe, the store laminate cabinet and the sample cabinet in the exhibition hall have different functions.
The laminate cabinet can not only store household goods, but also display articles such as books to increase the aesthetic feeling of the space.
Therefore, the importance of exhibition cabinet lighting is self-evident. The reasonable combination of aluminum trough lamps and cabinets can make our daily use more convenient.


 

02 key points for cabinet lighting design
generally speaking, the thickness of laminate board is 1-1.5cm, so the selected aluminum under cabinet lighting height is less than or equal to 0.8cm.



 The aluminum strip lamp of the cabinet cannot be directly installed at the front end of the cabinet, with a distance of 1.5-2CM.



03 cabinet aluminum strip lamp selection
Choose the aluminum strip lamp with side cabinet, which can cover the gap and make it more beautiful.

 Contrast effect

 Select the cabinet aluminum strip lamp with the light toward the inner side, which is less likely to produce glare compared with the straight cabinet aluminum strip lamp.



 Select the cabinet aluminum strip lamp with stripes on the side. The lines on both sides can make the aluminum strip lamp more firmly installed in the cabinet.



 04 installation method of cabinet aluminum strip lamp
Reserve a slot according to the size and length of the aluminum strip lamp in the cabinet, and clip the aluminum slot into the slot.
Note that a distance of 15-20mm shall be reserved at the front end to avoid the weakening of the load-bearing capacity of the board, which may lead to the instability of the cabinet.



 As shown in the figure, a wire slot shall be reserved on the side of the cabinet layer plate. The wires of each layer plate shall be routed to the back of the cabinet, and then the drive shall be connected as required, and the access hole shall be reserved.

you have any questions, please consult seeposh.
The information comes from the network. If there is infringement, you can contact to delete it